How to: Install BlackcatUSB Programmer on Windows7, drivers and properly use the device.
Below is a list of steps which will allow you to better use your USB jtag programmer.
By reading each step, you will learn how to use your USB jtag programmer safely and more efficiently. The USB Jtag programmer is one of the most powerful jtag programmers to date. This is the only USB jtag on the market that will exceed read & write speeds of excess 200KB/sec. With this kind of speed, you can program any unit within seconds!
Download USB JTAG Software: WinUSB 32bit Driver.(1.52 MB) here
Download 64bit Drivers: WinUSB 64bit Driver. (2.00 MB) here
Download Blackcat USB Software for XP/Vista/Win7 32/64 bit: here (RC12)
For Windows7 32/64bit OS you must have to install .Net Framework 4 ( web install or standalone ) you can download it from here.
Click on the link above to browse to the USB jtag drivers folder. Drag the files onto your desktop and
run the setup file. If this fails to install the drivers, simply right click the 'ezusbw2k' file and click install.
If this still doesn't work, then you should browse to your control panel. Inside your control panel you will see a systems icon, click on it. From there, you will click on the Hardware tab as illustrated below.
Once you're in device manager, browse to Universal Serial Bus controller. Connect your USB JTAG and you should see an item appear from the tree within the Universal Serial Bus Controller drop down. Once you see the item added, simply highlight it by clicking once and right clicking it and going to properties. If you have successfully installed the device you should see something similar to the illustration below.
If the device is coming up with a yellow circle, windows is indicating it could not be recognized, right click it, go to properties, then click on the driver tab. Once inside the driver tab click on update driver. Now choose to manually search for your driver, click next, then click "install from a list or specified location". Now browse to either your installation cd to the "USB JTAG Drivers" Folder, or wherever you have copied the folder over to. Install the driver and unplug and replug the USB JTAG device. If it still doesn't recognize, simply remove it from the device manager list and start over.
To set the proper device on the USB JTAG software is easy. Simply browse to Tools and then Config
and set the interface to the target of choice and hit OK.
IMPORTANT:
It's always important to connect your USB JTAG properly to the target device of your choice. But when we do this, We don't always understand how crucial it is to follow a set of steps when connecting the device.
When connecting the device, you must always have the USB jtag itself powered off, which means you must have the USB jtag cable running from your computer DISCONNECTED while connecting it to your header interface. After its connected, then and only then you may pluggin the power USB cord to the USB jtag device. Once the JTAG device is powered on and fully plugged in, then you may proceed to power on the main target device, whether it be a modified modem or a DCT receiver.
When Disconnecting the USB JTAG, you do the same as the above, except in reverse order. First you will disconnect the power from the target device whether it be a DCT receiver or router or a modem. Once powered down, then you may proceed to disconnect the USB cord from the USB jtag itself, then and only then you may remove the JTAG interface from the socket/header connector.
Following the steps above will result in a long and healthy life for not only your USB JTAG, but any hardware you may choose to flash with it.
0 comments:
Post a Comment